Rakam Latex Sealer
A high-quality, general-purpose insulating priming sealer, specially formulated as a primary coat for emulsion paint systems indoors & outdoors, to penetrate, seal, and block the absorption of very porous surfaces and to bond the dust that cannot be brushed away.
Main Features
- Excellent bonding strength.
- High penetrating power.
- Saturates and reinforces the surface.
- Improves the spreading rate of the subsequently applied coat.
Category: RAKAM STUCCO PUTTY
Description
Physical Specification
| Specific gravity | Approx. 1.39 g/cc |
| Solid by volume | Approx. 29% |
| Coverage rate | 10-12 M²/Liter |
| Dry film thickness | 20 Microns |
| Shelf life | 12 Months |
| Flash point | Not applicable |
| Finish | Matt or Eggshell |
| Drying time at 25 °C | Surface dry: approx. 1 hour, Hard dry: approx. 2 hours |
* A second coat can be applied after 2 hours…
Surface Preparation
The surface should be sound, dry and clean, free from dirt, oil, grease, and loose paint, or powdery materials…
A. Old Painted Surfaces
- Remove the old paint as much as possible.
- Sand the entire surface and remove all the dust.
- Wash down with Ammonia Water Solution.
- Rinse with clean water and allow to dry.
- Prime the surface to be painted with RAKAM Primer Sealer or RAKAM Latex Sealer.
- Fill cracks and holes with RAKAM Wall Putty or Acrylic Filler.
- After drying, sand the putty and clean the surface once again.
- Apply two coats of RAKAM Interior Emulsion.
A. New Surfaces
- Sand the surface until completely smooth, remove all the dust.
- Prime the surface to be painted with RAKAM Primer Sealer or RAKAM Latex Sealer.
- Apply 1-2 Coats of RAKAM Wall Putty or RAKAM Acrylic Filler.
- After drying, sand the putty and clean the surface.
- Apply two coats of RAKAM Interior Emulsion.
Instructions for use
Airless Spray Gun
| Tools | Brush |
| Type of thinner | Water |
| Percentage of thinning | 5-10% |
Air Spray Gun
| Type of thinner | Clean Water |
| Percentage of thinning | 10 – 15% max. by volume |
| Nozzle orifice | 1.5 – 2.0 mm |
| Output pressure | 2 – 3 bar |
Brush / Roller
| Type of thinner | Clean Water |
| Percentage of thinning | 10 – 20% max. by volume |
Subsequent Coats
- RAKAM Gloss Emulsion
- RAKAM Vinyl Silk
- RAKAM Exterior Acrylic Emulsion
- RAKAM – Tex Fine
- RAKAM – Tex Medium
- RAKAM – Tex Coarse
- RAKAM – gravio tex
Colours
White and Transparent
Packing
18 Lt./drum, 4lt gallon
Remarks
- Stir well before use…
- Avoid application below 5 °C or over 85% relative humidity.
- After using, clean the application tools immediately with water.
- Close container after use.
- Store in a cool and dry place.
- Keep out of reach of children.
- For more information, please do not hesitate to contact our Technical Department.
